Switch Motors Ready For Use…

Switch motors ready for use...
Switch motors ready for use…

I’ve been cleaning up the boxful of used Tortoises that I got at the last State Fair flea market.   I’ve removed the wires from each one, cleaned up the contacts, and soldered on a header block.  It’s my green frog version of the Terra Cotta Army.

Header Block

These headers are .156″ spacing right angle headers, which are designed to work with Molex connectors.  They work well enough on the Tortoise — whoever designed the board at Circuitron made something that almost, but not quite, works correctly with standard connectors.

IMG_0236.JPG

I used to use the EDAC connector plugs (available from Greenway), but these are $7 or so apiece, and they only mostly work.   They can be installed off by half a pin or so, which causes them to not work reliably.  They also can slip off due to vibration, since the board on the Tortoise isn’t the same thickness as the plug expects.

I’m going to use the RSMC (Remote Stall Motor Controller) board, which will take a logic hi/lo signal (such as from the Arduino, or a single pole single throw toggle/pushbutton) and swap the polarity on the 12V power to the tortoise.     These board have the matching connector to the headers I just soldered to all of these Tortii.

RSMC ImageI also can wire up the rail power to the RSMC, and I’ll get the correct frog power based on the switch position.  There are additional connectors that I can use for LED indicators on the fascia.

RSMC Installed

I have all the parts for the RSMC boards on my bench, except for the PC board.  I’ve ordered them from Seeed Studio in China, and they’re somewhere on the way between Shenzhen and here.   The total cost of the board, the components, and the connectors will be about $5 each, which certainly compares favorably to anything which uses the EDAC connector.

There’s a different edge connector available in the last few years:

tte-tortconn-2477-01

This one fits a little better, but not so much that it really is much better.  It does have the advantage of being easier to use on a circuit board (the Hare, of which I have one for testing, uses this connector).  It’s also a little bit cheaper (about $3 each).

But nothing beats the solid connection you get from the Molex connectors.  Combined with screw terminals for the other connections, I like how the RSMC is fairly easy to replace if necessary, and I don’t think they’d slip off in a Richter 8 earthquake (something my friends in California might worry about, but I don’t here in Minnesota.  Thank goodness for that.)

Maybe I should get started on laying track, so I have someplace to use these sometime soon.

Share